Peripheral-electronics iPod2car Bedienungsanleitung PDF herunterladen (Seite 17)

Symptom

Cause

Remedy

No Power

Blown fuse in vehicle fuse

block.

Replace fuse with same

amp rating. If the fuse

blows again, call tech

support.

No Power

Bad connection

Check cable and wiring

connection.

Alternator noise is heard

(Changes with Engine RPM)

Improper wiring creates a

ground loop

Install a Ground loop isola-

tor or seek professional

service from a local car

audio shop.

You can hear music from

the iPod but you cant con-

trol it from the radio.

The Firmware on the iPod

may not be updated.

Update the Firmware on

the iPod. See section 1.2

of this manual.

Radio is not recognizing

iPod2car interface

Bad cables or cables are

not connected properly

between converter box and

car radio

Check connection and

cables, push in ﬁ rmly.

Radio is not recognizing

iPod2car interface

Wrong conﬁ guration on the

interface

Select the right pconﬁ gu-

ration for your car. (See

section 1.5)

Radio is not recognizing

iPod2car interface

Yellow and black wires are

not connected to Constant

12V+ and Ground. (When

applicable)

Please read wiring instruc-

tions in chapter 2 of this

manual and see if your car

requires to connect the

yellow and black cable to

power and ground

iPod Audio is Low or

Distorted

iPod2car interface is con-

nected with an external CD

changer or other external

factory audio source

Disconnect the factory

external audio source.

iPod is not charging

Yellow and black wires are

not connected to Constant

12V+ and Ground. (

When

applicable

)

Please read your vehicles

section in this manual and

see if your car requires to

connect the yellow and

black cable to power and

ground

For consumer technical support call:

866-788-4237

in the US or 727-572-9255 ext.262 for international calls

Hours: 9:30 am-6:00 pm E.S.T. MON - FRI

3.2 Trouble Shooting

15

1 2 ... 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare